Top 10 Best hifonics amp 2018

So you have decided to Buy hifonics amp and you are looking for the hifonics amp to use?

Yeah I know!

So,

What if I tell you that choosing the perfect hifonics amp should not be so confusing?

Even though there are a lot of hifonics amp out there on the market?

Sounds interesting right?

Well, we have spent more than 10 hours on researching and reviewing these hifonics amp!

I have one promise to make!

If you buy the one which we suggest, then you will surely be having the best hifonics amp!

Sounds Interesting?

Have a quick glance at hifonics amp!

Best hifonics amp 2018 – Editior Choice!

So here is our list of the Top 10 hifonics amp

1. Hifonics Helios 2400 Watt 4-Channel 2-Ohm Car Amplifier Class A/B + OFC Amp Kit

Package Includes: . (1) Hifonics Helios 2400 Watt 4-Channel 2-Ohm Car Stereo Amplifier Class A/B Amp. (1) Rockville RWK4CU 4 AWG Gauge 100% Copper Complete Wire Kit OFC. (1) Rockville RTR172 17 Foot 2 Channel Twisted Pair RCA Cable Split Pin 100% Copper.  

By :- Hifonics

  • Specifically for the Hifonics Super Amps, the Primary Output Power should, according to CTA2006, be measured with 14.
  • Frosted Blue 4 gauge power wire with seamless crimp ring terminal 3 ft.
  • Triple shielded twisted pair RCA cables Rockville RTR172 17 Foot 100% Copper 2-Channel Twisted Pair RCA Cable  100% Oxygen Free Copper Also Available in: 3-Foot, 6-Foot, 12-Foot, 20-Foot and 25-Foot.
  • 4V DC supply, a 4-ohm load and with 1% or less total harmonic distortion in the output.
  • Frosted Clear/Blue 14 gauge flat speaker wire 17 ft.
  • Features: Hifonics Helios 2400 Watt 4-Channel 2-Ohm Car Stereo Amplifier Class A/B Amp Diagnostics: Three-stage protection circuits – Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel Class: Super A/B Class Variable Voltage: 9 – 0.

    2V Signal to Noise: >90dB Frequency Response: 20-20K Hz Crossover Type: Electronic Switched: HP/FULL/LP High Pass Crossover: 12dB Per Octave: 10Hz-500Hz (1x/10x) Low Pass Crossover: 12dB Per Octave: 30Hz-500Hz (1x/10x) Crossover Frequency Range: CH1 & CH2: Yes Crossover Frequency Range: CH3 & CH4: Yes Tone Control: ParaQ Bass Boost: 0-9dB Phase Shift: 0 – 180 degrees Power @ 2-Ohms: 4 x 300 RMS ; 4 x 600 Peak Power @ 4-Ohms: 4 x 150 RMS ; 4 x 300 Peak Mono Bridged @ 4-Ohms: 2 x 600 RMS ; 2 x 1200 Peak Total Channels: 4 Audio Inputs: Yes Audio Outputs: Yes, RCA Power Terminal: 12v/GND: 4 gauge Speaker Terminal Wire Gauge: 12g Certifications: CTA-2006-B Compliant Rockville RWK4CU 4 Gauge 2 Channel Complete Car Amplifier Installation Kit 100% Pure Copper RCA Cables 17 ft.

    2. HIFONICS Colossus 35th Aniv 3400w RMS Competition Mono Car Amplifier + Amp Kit

    Pre-Amp Circuitry: Low Noise PreAmplifier – Low voltage signal from the source unit comes into the amplifier pre-amplifier circuit with minimal distortion. Inputs: Tiffany Style RCA Connectors – Audiophile signal quality and maximum signal throughput with minimum distortion and maximum external noise rejection. Operation Mode: One Channel (Mono) – Mono mode is intended for subwoofers only.

    By :- Hifonics

  • The Colossus celebrates the 35th Anniversary of Hifonics with a CTA certified super amp.
  •  The Colossus represents Hifonics best signal processing and control features designed for a big mono amplifier.
  • The “Dual” means there are literally two amplifiers in one heat sink for system designs that need to develop large power without giving up additional space.
  • XCurve allows for chosen frequencies to be as stated (X1) or multiplied by 10.
  • The Colossus uses the Hifonics engineer’s technology, Ultra D Class in a Dual Mono block subwoofer amplifier that will deliver 3400 watts RMS.
  • Key among them is the Dual Mono Ultra D-Class topology which helps the Colossus develop huge power while minimizing voltage strain.
  • Features: Pre-Amp Circuitry: Low Noise PreAmplifier – Low voltage signal from the source unit comes into the amplifier pre-amplifier circuit with minimal distortion Inputs: Tiffany Style RCA Connectors – Audiophile signal quality and maximum signal throughput with minimum distortion and maximum external noise rejection Operation Mode: One Channel (Mono) – Mono mode is intended for subwoofers only Crossover / Signal Shaping: Accu-Cross & XCurve (X1/X10) – Accu-Cross crossovers allow for complete control of the signal directing to all speakers.

    Equalizer: ParaQ – Parametric Bass EQ with adjustments: Boost (0-10dB) Width (Narrow-Wide (On Center) Center Frequency (30Hz – 100Hz) 0 Gauge Power Amplifier Installation KitDesigned specifically for car audio systems over 1000 watts RMS to 3000 WattsMade from silver-tinned 100% virgin copper for a pure uninterrupted transfer of power and signalThe solid brass gold plated ANL Fuse Holder offers ideal protection for high powered systemsStrand Count: 4704BC-5W2 Compliant.

    Leave a Reply